PBR PANEL INSTALLATION GUIDE
PBR Panel can be used for a variety of different applications. Due to its design, it is a roofing and siding profile. When being used as a siding application, please refer to detail C for fastening. As the height on the sidewall may change the on-center attachment recommended, please consult load chart on page 1 (download product specifications).
Special residential note: In residential applications, Benton Metal Depot recommends the use of a solid deck and 30# felt. This recommendation is made to help eliminate condensation issues. 1"x 3" yellow pine batten strips are optional and must be attached 12" on center with a #8 x 3" screw 8" on center. Attaching the batten strips with a nail will substantially reduce the pullout or uplift value. The minimum pitch allowed with this panel is 1/12. The vertical attachment should be 16".
Step 2: Install Eave Drips/Roof Edge and Valleys according to details. Remember to use inside closure strips between Eave and Panel to eliminate water infiltration. Trim should be fastened 9" on center.
Step 3: Panel placement should begin on the Gable End opposite of the Prevailing Wind. Starter Edge should be the Lap Edge. (Opposite of Purlin Bearing Leg) after lying first panel check for squareness panel 2 should be lapped over Purlin Bearing Leg of panel 1 with the Lap Edge. A minimum 1" overhang is recommended at the Eave. Alternative method of panel placement may begin in the center of the roof. Often this method is used when the area covered is not divisible by 3' or traditional placement allows for a Pipe Flashing to occur in a Side Lap. Endlaps must be a minimum of 12" and two strips of Butyl Sealant is recommended 8" on uphill side of lap to keep watertight.
Step 4: Fasten panel according to Detail B or C depending on the area of application. Detail C shows additional screws to be spaced on each side of major Ribs for all Eaves, Ridges and Endlaps. When used as a siding panel, attach per detail B.
Step 5: Any field cutting must be done with metal nibblers, metal snips or blades designed for metal cutting. No cutting should be done on the roof, as it will cause iron shavings to be spread and adhere to roof panels. Proper cutting should be done exposed panel finished side down.
Step 6: Install remaining accessories such as Pipe Boots, Rib Profile Vent, Ridge Cap and Gable Flashing, Butyl Sealant, Caulking and Closures are necessary to maintain watertight seals as is Butyl Tape on all seams. Inspect screw fasteners to insure that they are installed properly. (See Detail D)
Step 7: Field clean the roof surface with broom to be sure iron shavings are removed.
PITCH ALERT!! RIB PANEL REQUIRES A MINIMUM 1/12 PITCH TO MAINTAIN WATER DRAINAGE. THIS PRODUCT IS CONSIDERED STRUCTURAL HOWEVER IT IS NOT SAFE TO WALK ON OVER OPEN PURLINS OR BATTENS.
ATTENTION INSTALLER!!! WHEN USING FASTENERS TO PENETRATE STEEL SHEETS THE IRON PARTICLES TEND TO GO AIRBORNE AND SETTLE ON THE SHEET. IT IS NECESSARY TO REMOVE THESE PARTICLES TO PREVENT EMBEDMENT AND RUST MARKS.
Code requirements vary from area to area and job type as well as roof configuration. Job specific engineering is available for a nominal fee by a structural engineer. The engineering is not a service provided by Benton Metal Depot and we accept no liability as to contracted work between parties. Please consult your local building code for proper procedures so we may assist you with your application.